Electronic Project Kits

Scroll Back to Page 33

Page 34

Scroll Forward to Page 35


SOUND ACTIVATED SWITCH FOR TAPE RECORDER 
(VOX SWITCH)


Turn on any tape recorder that has remote on/off jack 
(most cassettes). The circuit has feed back and delay 
circuit for robust operation. You could add a relay for
switching heavy loads; and tape recorders are not the limit. 
How about turning on lights via voice or a whistle? 
Circuit switches off after 6 seconds of silence.

80-130 ................................. $13.95


110 VOLT AC STROBE LIGHT KIT

Usually more practical then a battery operated strobe, 
runs on standard house current. The flash rate is adjustable 
from about one every three seconds to about three per 
second, Uses are as signal beacon, trade show kiosks, 
discos, etc.. Very bright flash can be seen for miles at 
night, Like those in airplanes. AC cord and plug not included.

80-140 .................................$29.95



LOGIC PROBE

An indispensible piece of equipment for testing and measuring 
digital equipment. Normally used for fault finding and testing 
but can also be a great help in design work or to see how 
digital equipment works.Switch for use in both TTL and 
CMOS. Detects very fast pulses. Output is 3 LED’s and 
audio indicator.

80-240 .................................$12.95


 
 
   

AUDIO AMPLIFIER MODULE

A good, variable gain amp to use with other projects, 
amplify radio circuits etc.. Use the National Semiconductor 
LM386 Intergrated Circuit, a well known and quality IC. 
Kit includes the data sheets from NS. Battery powered, 
may be operated from 4 to 12 volts DC. Powers a small 
speaker for personal listening.

80-170 ................................... $14.95


FM TELEPHONE TRANSMITTER

Miniature transmitter attaches to the phone line and 
transmits the conversation. Transmits 200 yards and 
more in most installations. Tunable to clear spot on the
FM band of your radio. Completely parasitic; i.e. uses 
the power from a telephone line and needs no battery. 
The circuit might be used to share or record conversation, 
but please do not use illegally.

80-160 ................................... $9.95

 
   


FIBER OPTIC AU

Uses a matched transmitter/ reciever pair from either Motorola 
or Industrial Fiber Optics Co. Allows you to send sound through 
plastic 1mm fiber optic cable. Two circuit boards with a microphone 
at one end and a speaker at the other 
(14’ fiber optic cable included).The maximum range is about 
220 yards. This can be a Science Fair winner.

80-260 ................................. $49.95


ULTRASONIC MOVEMENTDETECTOR

The circuit uses a matched pair of 40Khz transducer elements 
to detect movement out to about 22 feet. You may add a relay 
(not included) to switch a heavy appliance etc, the unit switches 
just an LED as supplied. The circuit can be switched to 
latch “on”. An ideal alarm circuit that can’t be easily fooled.

80-200 ................................. $29.95


OpAMP FUNCTION GENERATOR

A very low cost and simple circuit to generate square, 
pseudosinewave and triangular waveforms in the audio 
frequency range. Uses a quad OpAMP type LM384. 
This is an educational kit and recommended to understand 
electronics more thoroughly.

80-230 ................................... $11.95


ONE WATT AUDIO AMPLIFIER(MONAURAL)

While one watt is plenty for personal use 
(most small radios that have speakers produce less then 1/4 watt) 
the size is quite small and easy to fit it into a case with other 
projects. Battery operated from 3 to 15 volts, six volts is 
optimum. Output into an eight ohm speaker. 
The PC board is just 1-13/16” square, tallest component 
about 5/8” tall.

80-270 ................................... $10.95